Preventing Tailstrike During Go-around Near the Ground
The focus of this article is go-around near the ground, sometimes called, “rejected landing”. This follows our previous article: “A Focus on the Landing Flare” article published September 2020 and “A Focus on the Takeoff Rotation” published January 2021. Those articles provided recommendations for avoiding tailstrikes when performing landing flare and takeoff rotation. There is […]
Inappropriate V/S Target during Autoflight Mode Reversion
Two cases of inappropriate V/S target during an autoflight reversion to V/S mode after a go-around were recently reported to Airbus. In both cases, the inappropriate V/S target resulted in a pitch down command of the autopilot with high thrust. The flight guidance used the previously selected V/S value set during the preceding ILS glide […]
Thrust Reverser Selection is a Decision to Stop
The SOP for landing requests that the flight crew perform a full stop landing after thrust reversers selection. However, in-service flight data analysis revealed that the equivalent of one go-around per month is performed after selection of thrust reversers. This article describes an event where the flight crew performed a go-around after they had selected […]
Prevention of Unstable Approaches
Unstable approach has been a problem since the very beginning of commercial aviation. Even so, it is still one of the most common contributing factors to many of the incidents and accidents that occur on landing today. Regardless of the changes or cycles our industry faces, this article is a timeless reminder for the importance […]
A Focus on the Landing Flare
There were several cases of aircraft touching down with their nose landing gear first or hard landings reported to Airbus over the last 2 years. This article will present some key points coming from the analysis of two of these incidents and recall the operational recommendations for performing the flare phase that are key to […]
Introduction to the Soft Go-Around Function
The “all engines” go-around is a very dynamic procedure with high accelerations created by the application of TOGA thrust. Yet in-service experience has shown that as long as both engines are operating, a lower thrust can still be sufficient to perform a safe go-around.As a safety enhancement, Airbus has introduced the Soft Go-Around (SGA) function, […]
Flying a Go-Around Managing Energy
Airbus recently performed some research on the quality of go-around execution. This involved examining nearly 500,000 approaches flown by many airlines from around the world.The results highlighted that in some cases crews are choosing not to apply the Airbus Standard Operating Procedure (SOP) for the go-around phase.Particularly when a go-around was performed above 1,200 ft, […]